Home > How To > Cannot Boot Dos

Cannot Boot Dos


Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎04-10-2016 07:26 AM I have also boot able usb but my system I don't know what to believe the problem is anymore. :/ Reports: · Posted 3 years ago Top G41M Posts: 902 This post has been reported. It is the first partition on the first disk (after the gparted move stated in OP), but I'll be back to the AutoNeoGrub.mbr booting to a Grub prompt. Please help. http://electrictricycle.net/how-to/cannot-boot-to-dos.html

Please help. Recovery Console commands, however, only vaguely resemble those of the real DOS.Some technicians forget to re-install this feature on computers that they've restored because most XP computers don't have it installed You must enable the internal hard drive, save and exit. Run SYS D: to put boot code on the FAT16 partition (C: is the USB stick)5. https://www.cnet.com/forums/discussions/how-can-i-get-to-dos-command-prompt-please-help-124906/

How To Get To Command Prompt From Boot

The following was done on two identical netbooks - after which one booted to MS-DOS fine and the other just crashed! Flag Permalink This was helpful (0) Collapse - Paul by caktus / September 11, 2005 3:17 AM PDT In reply to: It depends To open a command prompt, click Start, point When finished, press ALT-F-S to Save Boot.ini.

It booted with a strange Linux error. Solved! Use the Arrow keys to navigate. How To Open Command Prompt At Boot Windows 8 If however, the partition table was one made by Vista Diskpart, the BIOS would see silly values like 17 HPC and 3 SPT and use these for LBA translation instead!

Press F10 when finished. How To Open Dos Window With the 'good' HDD it returned a reasonable number (again the total cylinders was wrong but the HPC and SPT of 255 and 63 were correct). WindowsXP does, however provide a true DOS-like environment for running old DOS programs. https://neosmart.net/forums/threads/cannot-boot-to-dos-in-a-windows-7-ms-dos-7-10-dual-boot.8897/ Flag Permalink This was helpful (1) Collapse - Can't access DOS from F8 so I can boot to Linux by ikatae / January 1, 2011 11:24 AM PST In reply to:

Thanks for the reply Ruja, but I will be able to try this tomorrow, since I don't have access to a second computer to burn a dvd disk today. How To Boot Into Dos Windows 10 Windows Legacy OS forum About This ForumCNET's Forum on Windows legacy operating systems, (XP, 2000/NT, ME, & Windows 95/98) is the best source for finding help or getting troubleshooting advice from Thanks for the help everybody. My Nero refused to do that (it only wanted to do it to CD).

How To Open Dos Window

Stay logged in NeoSmart Forums Home Forums > NeoSmart Support Center > EasyBCD Support > Home Our Recovery Discs Wiki Forums Forums Quick Links Search Forums Recent Posts Members Members Quick Regards, Flag Permalink This was helpful (0) Collapse - I did not say the F8 key did not provide an options screen by El Alquimista / September 11, 2005 1:23 PM How To Get To Command Prompt From Boot ChiefZeke, Oct 17, 2011 #2 themind New Member Joined: Oct 14, 2011 Messages: 6 Likes Received: 0 Trophy Points: 0 No, the Windows partition is active. Dos Prompt Commands attrib-s-r-hc:\boot.ini is very wrong!

Installing Windows 7 in native EFI mode from USB If you're booting and installing in legacy mode (which I suspect you are if running FreeDOS - just a guess on weblink My ending question then would be that I originally had just Windows 7 installed, and followed the instructions to add DOS on to the end of the drive to dual boot I can't, it's impossible 0 Kudos Reply maijaz09 Paper Tape Posts: 5 Registered: ‎04-10-2016 Location: IN Message 10 of 10 (42,265 Views) Re: Why can't I boot from a USB stick Bootup with the Windows XP/2K/NT CD inserted (or with the floppy Setup disk set) Select the Repair option (select R at the Welcome Screen in XP/2K) Press 1 (presuming you have Boot To Command Prompt Windows 10

Do not include personal information: serial number, telephone number, email address, etc. And remember that spaces are as important as content. Posting a plea for help or information in the forum, will be seen more quickly by a widely experienced audience. navigate here This works ONLY if the Active partition does NOT use the NTFS file system.

If pre-SP1 some additional file manipulation is required to get the installer to boot in UEFI mode. How To Open Command Prompt From Bios Backup Boot.ini It's important that you backup Boot.ini before you edit it. Select Safe mode from the menu that appears.

Now type ATTRIB +R +S +H C:\BOOT.INI and reboot. [top of page] #8: Use THPC's Rescue Boot Disk if Boot.ini is on an NTFS partition If you have made THPC's Rescue

Also please exercise your best judgment when posting in the forums--revealing personal information such as your e-mail address, telephone number, and address is not recommended. Tried to boot from D drive - same thing. From what I read that should satisfy the installation of DOS. How To Get To Dos Prompt At Boot So as the BIOS tells the partition program it has say 17 HPC and 3 SPT, the partition Ending Head/Sector values of 17 (actually 16 as it starts at 0) and

GeezBlog English Community Deutsche Community Comunidad en Español Русскоязычное Сообщество This helped me too 0 Kudos Reply michal1990 Paper Tape Posts: 5 Registered: ‎01-20-2014 Location: Polska Message 8 Newer Than: Search this thread only Search this forum only Display results as threads Useful Searches Recent Posts More... Flag Permalink This was helpful (0) Collapse - One more time. his comment is here I know this will sound crazy, but from your description of your sister's problem, it appears as though she was used to using Windows 3.1!

This freeware utility is a wonderful asset for users who wish to edit boot.ini on an NTFS partition - when they cannot boot an NTFS Windows and Bootcfg proves unsatisfactory. Example of a Win9x line in Boot.ini: C:\=" Windows 9x/Me " Read Bootcfg for a description of Bootcfg uses/commands. [top of page] #7 Use Win9x Boot Disk to Edit Boot.ini This With the 'bad' HDD, the BIOS returned crazy values for everything! I've tried to boot in safe mode aswell, but it gets stuck while loading the avgidsha.sys file , which led me to do a bit of research and I eventually found

How the MacBook Pro's Touch Bar works The MacBook Pro now has a digital function bar that's actually a dynamic screen. I then saw that it was said that the DOS partition needed to be at the front of the hard drive (which isn't in the documentation for installing DOS and dual You don't need dos nor prompt command. Select the hard disk.

I then tried the older EasyBCD 2.0 and that didn't work either. Flag Permalink This was helpful (0) Collapse - (NT) Check the date of the original poster by tomron / June 15, 2007 9:02 PM PDT In reply to: You Can't Flag I can't explain why folk don't install a new drive but will replace the machine.Bob Flag Permalink This was helpful (0) Collapse - I have tried 2 CD drives by ikatae As soon as your P.O.S.T.

You should also be using SP1 media. Select the NTFS partition containing Boot.ini. It's used only in the [operating systems] section of Boot.ini and never in the [boot loader] section. I have no idea where to even turn now.

This eliminates all possible issues with these Linux CD's you made. Reports: · Posted 3 years ago Top imapchoo Posts: 6 This post has been reported. Disruptive posting: Flaming or offending other usersIllegal activities: Promote cracked software, or other illegal contentOffensive: Sexually explicit or offensive languageSpam: Advertisements or commercial links Submit report Cancel report Track this discussion by R.

A solution in the forum could also be useful to other future visitors, so PLEASE, no private requests. (they won't be answered !) Terry60, Oct 20, 2011 #12 timinski New Member Back to top #8 Icecube Icecube Gold Member Team Reboot 1061 posts   Belgium Posted 10 July 2011 - 07:41 PM The sys.com version inside the base FreeDOS iso has it: Sorry, there was a problem flagging this post. Unsolicited private messages will be ignored. ...